When your scope has multiple channels but you only own a single probe lead, measuring several points means constant swapping. A multi-lead oscilloscope probe set can remove that bottleneck, and this JINHAO P6100 set comes from a US seller, with the whole package priced at USD 29.99. The question is whether this general-purpose four-pack matches your bench needs.
Quick verdict
This JINHAO P6100 set gives you a practical number of leads in two sealed packages, with switchable attenuation and a stated 100 MHz bandwidth in 10X mode. For standard oscilloscope work on circuits that don't require specialty probes, it's a convenient way to populate several channels at once. The main caveat is the 1X mode's 6 MHz limit, which means high-frequency measurements should use the 10X setting.
Who it suits
You'll get the most from this set if you regularly probe multiple test points in a circuit, such as comparing input and output signals or monitoring several supply rails. The multi-probe layout means you can leave connections in place without having to move leads between measurements. It also fits work with scopes that have up to 100 MHz bandwidth, as described for the probe.
What stands out from the listed details
The set ships as two packages of two probes, giving you four clip probes total. Each probe uses a coaxial reed switch for 1X/10X selection and features an interchangeable tip and modular construction. The listed bandwidth is 100 MHz at 10X and DC to 6 MHz at 1X, with input resistance of 10 MΩ at 10X and 1 MΩ at 1X. The compensation range spans 10 to 35 pF, and the cable length is 120 cm, which gives you reasonable reach around a bench setup.
4 Four New 100MHZ Oscilloscope clip probes for HP Tektronix Hitachi, US seller
This product note covers the specific listing: a JINHAO P6100 set of 100 MHz clip probes intended for HP, Tektronix, and Hitachi instruments. The description emphasizes a general-purpose, bench-friendly design with a stated operating temperature range of -10°C to +50°C. If you need to equip several channels without buying separate sets, this multi-probe package directly addresses that.
Meaningful trade-offs
The biggest trade-off is the 1X bandwidth ceiling. At 1X, the probe is rated to only 6 MHz, so relying on 1X for high-speed signals will distort or attenuate them; you'll want to switch to 10X for signals near the scope's 100 MHz limit. Because the compensation range is 10 to 35 pF, scopes with input capacitance outside that window may not produce clean square waves, but many common oscilloscopes fall into that range. Also, the set is intentionally general-purpose, so if you need a high-voltage or differential probe, this isn't that tool.
Bottom line
At USD 29.99, this JINHAO P6100 set is a cost-conscious way to add multiple 100 MHz clip probes to your bench. It suits technicians and hobbyists who want multiple channels populated for ordinary signal tracing, and the main adjustment is to keep the switch in 10X mode for anything above a few megahertz. If that matches your work, this set gives you plenty of leads for the price.
