Your multimeter and your oscilloscope need different test leads, and choosing the wrong kit leaves you with a probe that either clips onto the wrong input or misses the signal entirely. In the test leads, probes, and fixtures space, the two kits here sit at opposite ends of the price spread: the JINHAO oscilloscope probe pair costs USD 17.99, while the multimeter hard point set costs USD 7.49, a $10.50 difference. That gap reflects what each set is built to do.
Quick verdict: If you work with an oscilloscope, get the JINHAO TP6100 kit. If your main tool is a multimeter, the hard point set is the practical pick.
At a glance:
| Feature | JINHAO Oscilloscope Clip Probe Kit | Multimeter Hard Point Lead Set |
| Price | USD 17.99 | USD 7.49 |
| Intended instrument | Oscilloscope | Multimeter |
| Bandwidth / rating | DC to 100 MHz (10X) | 1000V, 20A |
| Attenuation | 1X / 10X switch | None |
| Included extras | Two probes, interchangeable tips | Alligator clip, thermocouple |
| Probe tip | Clip probe | Pin tip |
Where each kit wins:
- The oscilloscope kit is the better match for signal-level work because it is designed to compensate with the scope's input capacitance. It gives you the probing response you need for waveform analysis.
- The multimeter set is the better match for everyday electrical measurements because it is built for direct connection to meter jacks and covers a wide range of voltage and current.
Product notes:
2x 100MHz Oscilloscope Scope analyzer Clip Probe test leads kit for HP Tektronix
The JINHAO TP6100 pair is an oscilloscope probe kit. It is rated for scopes with bandwidth up to 100 MHz and includes a 1X/10X switch, so you can reduce the signal when needed. The input resistance is 10MΩ on the 10X range, and the compensation range of 15 to 45 pF covers many popular scopes. Each probe has a 120cm cable and an interchangeable tip, and the kit ships with two probes. The main drawback is the voltage ceiling: 300V on 1X and 600V on 10X, which is below the 1000V rating of the multimeter leads. This is a specialized tool for scope work, not a universal probe.
Multimeter Hard Point Test Leads Set 1000V 20A Meter Probes
The hard point lead set is a multimeter test lead kit. It is rated for up to 1000V and 20A, so it covers typical household, automotive, and electronics measurements. The probe tips are stainless steel and marked with + and - signs, and the rubber shrouds provide grip. The set includes a probe with an alligator clip and a thermocouple that reads from 0 to 400°C. The limitation is that it is not an oscilloscope probe: it has no attenuation switch and no bandwidth rating, so using it on a scope would give you unattenuated signals and limited high-frequency performance. It only works with multimeters that accept 4mm shrouded banana plugs.
Final choice by use case: For oscilloscope work, the JINHAO TP6100 kit is the one to choose. For multimeter work, the hard point set offers higher voltage and current ratings, a thermocouple, and an alligator clip at a lower price. Select based on the instrument on your bench, not on price alone.
